Checking The Engine-Oil Level; Checking The Hydraulic-Fluid Level - Toro 22322 Operator's Manual

Note: The cap is tethered to the fuel tank.
4. Add unleaded fuel to the fuel tank, until the level is just
below the bottom of the filler neck.
Important: This space in the tank allows fuel to
expand. Do not fill the fuel tank completely full.
5. Install the fuel tank cap securely, turning it until it clicks.
6. Wipe up any fuel that may have spilled.

Checking the Engine-Oil Level

Service Interval: Before each use or daily
1. Park the traction unit on a level surface, lower the
loader arms, and shut off the engine.
2. Remove the key and allow the engine to cool.
3. Open the hood.
4. Clean around the oil dipstick
1. Oil dipstick
5. Pull out the dipstick and wipe the metal end clean
(Figure 15).
6. Slide the dipstick fully into the dipstick tube
7. Pull the dipstick out and look at the metal end.
8. If the oil level is low, clean around the oil-filler cap and
remove the cap (Figure
1. Filler cap
9. Slowly pour only enough oil into the valve cover to
raise the level to the F (Full) mark.
(Figure 15).
Figure 15
2. Metal end
(Figure
16).
Figure 16
2. Valve cover
Important: Do not overfill the crankcase with oil
to prevent damaging the engine.
10. Replace the filler cap and dipstick.
11. Close the hood.
Checking the Hydraulic-Fluid
Level
Service Interval: Every 25 hours
Hydraulic Tank Capacity: 45.4 L (12 US gallons)
Refer to Changing the Hydraulic Fluid (page 41)
hydraulic-fluid specifications.
Important: Always use the correct hydraulic fluid.
Unspecified fluids will damage the hydraulic system.
1. Remove the attachment, if one is installed; refer to
Removing an Attachment (page
2. Park the traction unit on a level surface, lower the
loader arms, and fully retract the tilt cylinder.
3. Shut off the engine, remove the key, and allow the
engine to cool.
4. Open the hood and remove the left side screen.
5. Clean the area around the filler neck of the hydraulic
tank (Figure
6. Remove the cap from the filler neck and check the fluid
level on the dipstick
The fluid level should be between the marks on the
dipstick.
15).
1. Filler-neck cap
7. If the level is low, add enough fluid to raise it to the
proper level.
8. Install the cap on the filler neck.
9. Replace the left side screen and close the hood.
18
22).
17).
(Figure 17).
Figure 17
2. Dipstick
for