Specifications
Note:
Specifications and design are subject to
change without notice.
Models
68048 and 68049
Width
92 cm (36.5 inches)
Length (operating)
177 cm (70 inches)
Height (operating)
99 cm (39 inches)
Weight
102 kg (225 lb)
Attachments/Accessories
A selection of approved attachments and accessories
are available for use with the machine to enhance
and expand its capabilities. Contact your Authorized
Service Dealer or Distributor or go to www.Toro.com
for a list of all approved attachments and accessories.
Operation
Note:
machine from the normal operating position.
68050 and 68051
117 cm (46 inches)
Checking the Engine-Oil
190.5 cm (75
Level
inches)
99 cm (39 inches)
Service Interval: Before each use or daily
112 kg (245 lb)
The machine comes from the factory with oil in the
engine crankcase. However, it may be necessary to
add oil. Add only enough oil to raise the level to the
Full mark on the dipstick; refer to
Oil (page
Oil Type: 4-cycle engine oil that meets or exceeds the
requirements for API service category SJ or higher
Models
68048 and 68049
68050 and 68051
Important:
level in the crankcase is too low or too high, you
may damage the engine.
Note:
use the other viscosities shown in the chart when
the average temperature in your area is within the
indicated range
1.
2.
3.
9
Determine the left and right sides of the
16).
Crankcase Capacity
0.58 L (0.61 US qt)
1.1 L (1.2 US qt)
If you run the engine while the oil
Use SAE 10W-30 for general use. You can
(Figure
8).
Figure 8
Position the machine on a level surface.
Set the Dyna-Clutch lever to the Stop position,
shut off the engine, wait for all moving parts to
stop, and turn off the engine switch.
Clean around the dipstick
dirt cannot fall into the fill port and damage the
engine.
Servicing the Engine
g013375
(Figure
9) so that