Table of Contents
Advertisement
Testing the Dyna-Clutch
Lever
Testing the Dyna-Clutch Operation
Ensure that the area is clear of any debris or
bystanders before beginning the testing procedures.
1.
Start the trowel, engage the Dyna-Clutch lever,
and run the machine for a few moments.
2.
Move the Dyna-Clutch lever to the Stop position.
3.
Watch the blades for any sign of continued
rotation.
If the blades do not stop, there is too much
tension on the cable and spring. Shut off the
engine and decrease the amount of tension
to allow the Dyna-Clutch lever to disengage
completely.
Ensure that there is still enough tension on the cable
and spring to prevent parts from coming unhooked
during operation. If the tendency for the blades to
rotate when the Dyna-Clutch lever is disengaged
cannot be adjusted out of the system without taking all
tension off of the cable and spring, carefully inspect
the drive belt and Dyna-Clutch lever system for wear
or damage. Ensure that all parts are operating freely.
If the Dyna-Clutch lever does not stop the blades, see
an Authorized Service Dealer.
Testing the Dyna-Clutch Lever
Adjustment
Important:
Ensure that the testing of the
Dyna-Clutch lever is done is a clear and open area.
Important:
Clear the test area of bystanders.
1.
Move the Dyna-Clutch lever to the S
refer to
Dyna-Clutch Lever (page
2.
Start the trowel.
3.
Move the fuel valve to the O
29).
Important:
You must move the fuel valve
to the O
position before continuing this
FF
procedure.
position;
TOP
8).
position
(Figure
FF
23
Figure 29
1. Fuel valve
4.
Hold onto the handle and engage the
Dyna-Clutch lever; refer to
(page
8).
5.
Let go of the handle.
The Dyna-Clutch lever should switch to the
S
position within 1 rotation. If it does not,
TOP
keep clear of the area and wait for the machine
to run out of fuel.
Note:
If the Dyna-Clutch does not stop the
machine within 1 rotation, adjust the Dyna-Clutch
or bring the machine to an authorized service
location; refer to
(page
20).
6.
Move the Dyna-Clutch lever to the S
Adjusting the Blades
Adjust the blades to remove excessive shaking of the
machine.
1.
Disconnect the spark plug wire and move the
Dyna-Clutch lever to the S
2.
Place 3 or 4 blocks of equal height under the
stationary blade guard (outer ring) to raise the
blades off of the floor.
Note:
Ensure that the blocks are clear of the
blades so that the blades can be rotated without
touching the blocks.
2. Off position
Dyna-Clutch Lever
Adjusting the Dyna-Clutch
TOP
position.
TOP
g025040
position.
Advertisement
Table of Contents
