Controls System Maintenance; Adjusting The Traction Control Alignment; Adjusting The Traction Control Neutral Position - Toro 22322 Operator's Manual

Controls System
Maintenance
The factory adjusts the controls before shipping the traction
unit. However, after many hours of use, you may need to
adjust the traction control alignment, the neutral position of
the traction control, and the tracking of the traction control
in the full forward position.
Important: To adjust the controls properly, complete
each procedure in the order listed.
Adjusting the Traction Control
Alignment
If the traction control bar does not rest flush and square
with the reference bar when in the full backward position,
immediately complete the following procedure:
1. Park the traction unit on a flat surface and lower the
loader arm.
2. Shut off the engine and remove the key.
3. Pull straight back on the traction control so the front
of the control contacts the reference bar
Figure 53
1. Front of the control (out of
alignment)
4. If the front of the traction control does not rest square
and flush with the reference bar, loosen the flange nut
and bolt in the stem of the traction control
Figure 54
1. Traction control
(Figure 53).
2. Reference bar
(Figure 54).
2. Stem, bolt, and nut
5. Adjust the traction control so that it rests flush against
the reference bar when you pull it straight back
54 and Figure 55).
6. Tighten the flange nut and bolt in the traction control
stem.
Adjusting the Traction Control
Neutral Position
If the traction unit creeps forward or backward when the
traction control is in neutral and the unit is warm, immediately
complete the following procedure:
1. Lift/support the traction unit so that both tracks are
off the ground.
2. Open the rear-access cover.
3. Loosen the jam nuts on the traction rods, under the
control panel (Figure
2
1
1. Traction rod
4. Start the traction unit and set the throttle to about 1/3
open position.
39
Figure 55
56).
g013014
Figure 56
2. Jam nut
(Figure