Table of Contents
Advertisement
Belt Maintenance
Checking the
Alternator-Belt Tension
Service Interval: Before each use or daily
Every 500 hours (Refer to the engine owner's
manual for instructions.)
Proper tension of the belt allows 10 mm (3/8 inch) of
deflection when a force of 10 kg (22 lb) is applied on
the belt midway between the pulleys.
If the deflection is not 10 mm (3/8 inch), perform the
following steps:
1.
Loosen the alternator-mounting bolt.
Figure 68
1. Mounting bolt
2.
Increase or decrease the alternator-belt tension
and tighten the bolt.
3.
Check the deflection of the belt again to ensure
that the tension is correct.
g020537
2. Alternator
Controls System
Maintenance
Adjusting the Controls
The factory adjusts the controls before shipping the
machine. However, after many hours of use, you
may need to adjust the traction control alignment,
the N
position of the traction control, and the
EUTRAL
tracking of the traction control in the full forward
position.
Contact your Authorized Service Dealer to adjust the
controls of your machine.
46
Advertisement
Table of Contents
