Table of Contents
Advertisement
Pre-Maintenance
Procedures
Using the Cylinder Locks
WARNING
The loader arms may lower when in the raised
position, crushing anyone under them.
Install the cylinder lock(s) before performing
maintenance that requires raised loader arms.
Installing the Cylinder Locks
1.
Remove the attachment.
2.
Raise the loader arms to the fully raised position.
3.
Shut off the engine and remove the key.
4.
Remove the 2 pins securing the cylinder lock to
the posts on the side of the machine.
5.
Slide the cylinder lock over the lift-cylinder rod
(Figure
32).
Figure 32
1. Cylinder lock
2. Lift-cylinder rod
6.
Repeat step
4
and
machine.
7.
Slowly lower the loader arms until the cylinder
locks contact the cylinder bodies and rod ends.
3. Pin (2)
5
for the other side of the
Removing and Storing the
Cylinder Locks
Important:
Remove the cylinder locks from the
rods and fully secure them in the storage position
before operating the machine.
1.
Start the engine.
2.
Raise the loader arms to the fully raised position.
3.
Shut off the engine and remove the key.
4.
Remove the pins securing the cylinder locks.
5.
Place the cylinder locks on the posts on the
sides of the machine and secure with the pins.
6.
Lower the loader arms.
Accessing Internal
Components
WARNING
Opening or removing covers, hoods, and
screens while the engine is running could
allow you to contact moving parts, seriously
injuring you.
Before opening any of the covers, hoods, and
screens, shut off the engine, remove the key
from the key switch, and allow the engine to
cool.
Opening the Hood
1.
Use the latch key to unlock the lever.
g365284
2.
Use the lever to lift open the hood
3.
Secure the prop rod.
28
Figure 33
g365296
Advertisement
Table of Contents
