Lubrication; Greasing The Machine; Engine Maintenance; Engine Safety - Toro TX 700 Operator's Manual

Tx 700 narrow track compact tool carrier
Table of Contents

Advertisement

Lubrication

Greasing the Machine

Service Interval: Before each use or daily (Grease
immediately after every washing.)
Grease Type: General-purpose grease.
1.
Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2.
Shut off the engine and remove the key.
3.
Clean the grease fittings with a rag.
Figure 39
4.
Connect a grease gun to each fitting.
5.
Pump grease into the fittings until grease begins
to ooze out of the bearings (approximately 3
pumps).
6.
Wipe up any excess grease.

Engine Maintenance

Engine Safety

Shut off the engine before checking the oil or
adding oil to the crankcase.
Do not change the engine governor setting or
overspeed the engine.
Keep your hands, feet, face, other body parts,
and clothing away from the muffler and other hot
surfaces.

Servicing the Air Cleaner

Service Interval: Before each use or daily—Check
Every 25 hours—Remove the air-cleaner cover,
clean out debris, and check the air-filter-service
indicator.
Every 500 hours—Replace the air filter.
Servicing the Air-Cleaner
Important:
To prevent engine damage, always
operate the engine with the air filter and cover
installed.
Important:
Replace the air-cleaner filter only
when the service indicator shows red. Changing
the air filter before it is necessary only increases
the chance of dirt entering the engine when you
remove the filter.
g411225
1.
Park the machine on a level surface, engage
the parking brake (if equipped), and lower the
loader arms.
2.
Shut off the engine and remove the key.
3.
Open the hood and secure the prop rod (if
applicable).
31
the air-filter-service indicator.
Figure 40
g367365

Advertisement

Table of Contents
loading

This manual is also suitable for:

223512235222351g

Table of Contents