Replacing The Water Separator Filter; Replacing The In-Line Fuel Filter; Checking The Fuel Lines And Connections - Toro TX 700 Operator's Manual

Replacing the Water
Separator Filter
Service Interval: Every 500 hours
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Open the hood.
4. Clean the area where the filter canister mounts.
Figure 46
1. Water separator
5. Remove the filter canister and clean the
mounting surface.
6. Lubricate the gasket on the new filter canister
with clean oil.
7. Fill the canister with fuel.
8. Install the filter canister by hand until the gasket
contacts the mounting surface, then rotate it an
additional 1/2 turn .
9. Close the hood.
Replacing the In-Line Fuel
Filter
Service Interval: Every 500 hours
1. Park the machine on a level surface, engage the
parking brake, and lower the loader arms.
2. Shut off the engine and remove the key.
3. Remove the rear cover; refer to
Rear Cover (page
4. Replace the filter as shown.
Note:
Ensure that the markings on the filter
follow the fuel flow direction.
g365572
Checking the Fuel Lines
and Connections
Service Interval: Every 400 hours/Yearly (whichever
Inspect the fuel lines and connections for deterioration,
damage, or loose connections. Tighten any loose
connections and contact your Authorized Service
Dealer for assistance in fixing damaged fuel lines.
35
Removing the
29).
Figure 47
comes first)
g033082