Lifting The Machine - Toro TX 700 Operator's Manual

Figure 29
1. Tie-down loops
Unloading the Machine
1. Lower the ramp(s).
2. Unload the machine from the trailer with the
heavy end up the ramp, carrying loads low.
•
If the machine has a full load-bearing
attachment (e.g., bucket) or a
non-load-bearing attachment (e.g.,
trencher), back it down the ramp.
•
If the machine has an empty load-bearing
attachment or no attachment, drive it forward
down the ramp.
Figure 30
1. Machine with full
attachment or
non-load-bearing
attachment—back the
machine down the
ramp(s).
g411229
g204458
2. Machine with empty or
no attachment—drive the
machine forward down the
ramp(s).

Lifting the Machine

Remove any attachments and lift the machine using
the 4 lift points.
Do not exceed a 20-degree angle when lifting the
machine; use the minimum chain lengths provided
below.
1. Chain length for rear lift point (2)—118.9 cm (46.8 inches)
2. Chain length for front lift point (2)—206.2 cm (81.2 inches)
25
Figure 31
g377831