Toro TX 700 Operator's Manual page 42

4. Loosen the bolts on the rear cover and remove
the cover.
Figure 56
1. Rear cover
5. Loosen the jam nut and adjust the tensioning
screw until the track deflection is 13 mm (1/2
inch).
Figure 57
1. Tensioning screw
6. Tighten the jam nut.
7. Install the cover and tighten the bolts.
8. Repeat the procedure for the other track.
9. Drive the machine, then park the machine on a
level surface, engage the parking brake, shut off
the engine, and remove the key.
10. Verify that the track deflection is 13 mm (1/2
inch). Adjust if necessary.
g366295
2. Bolt (2)
g363401
2. Jam nut
Replacing the Tracks
Removing the Tracks
1. Remove any attachments.
2. Park the machine on a level surface, ensuring
that only 1 sprocket half is engaged with the
track.
1. Sprocket half
3. Lower the loader arms.
4. Shut off the engine and remove the key.
5. Raise the machine off the ground so that the
bottom of the track is at least 10.2 cm (4 inches)
off the ground. Support the machine using jack
stands.
Note:
Use jack stands rated for your machine.
WARNING
Mechanical or hydraulic jacks may fail to
support the machine and cause serious
injury.
Use jack stands when supporting the
machine.
6. Loosen the bolts on the rear cover and remove
the cover.
1. Rear cover
42
Figure 58
Figure 59
2. Bolt (2)
g366389
g366295