Philips S9711/33 Manual page 23

Problem
Water is leaking from the
bottom of the shaver.
The SmartClean system
does not work when I
press the on/off button.
The shaver is not entirely
clean after I clean it in the
SmartClean system.
The shaver is not fully
charged after I charge it
in the SmartClean system.
Possible cause
During cleaning, water may
collect between the inner
body and the outer shell of the
shaver.
The SmartClean system is not
connected to the mains.
You have not placed the shaver in
the SmartClean system properly,
so there is no electrical connection
between the SmartClean system
and the shaver.
The cleaning cartridge needs
replacement.
The cleaning cartridge is empty.
The replacement symbol flashes
to indicate you have to replace
the cleaning cartridge.
You have used another cleaning
fluid than the original Philips
cleaning cartridge.
The drain of the cleaning
cartridge might be blocked.
You have not placed the shaver
in the SmartClean system
properly.
Solution
This is normal and not dangerous
because all electronics are enclosed in a
sealed power unit inside the shaver.
Put the small plug in SmartClean system
and put the adapter in the wall socket.
Press down the top cap ('click') to ensure
a proper connection between the shaver
and the SmartClean system.
Replace the cleaning cartridge (see
chapter 'Cleaning and maintenance').
Place a new cleaning cartridge in
the SmartClean system (see chapter
'Cleaning and maintenance').
Only use the Philips cleaning cartridge.
Push the hairs down the drain with a
toothpick.
Press down the top cap ('click') to ensure
a proper connection between the shaver
and the SmartClean system.
ENGLISH
23 23