Toro Groundsmaster 3200 Series Operator's Manual page 22

Winter enclosure
Hide thumbs Also See for Groundsmaster 3200 Series:
Table of Contents

Advertisement

Maintenance
Recommended Maintenance Schedule(s)
Maintenance Service
Interval
After the first 250 hours
Cleaning
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the switch before you do any maintenance.
Cleaning the Cab
Important:
Use care around the cab seals
32). If you are using a pressure washer, keep the
washer wand at least 0.6 m (2 ft) away from the
machine. Do not use the pressure washer directly
on the cab seals, glass seals, and under the rear
overhang.
Figure 32
1. Seal
Maintenance Procedure
• Clean the cab air filters (replace them if they are torn or excessively dirty).
(Figure
g302075
2. Keep wand 0.6 m (2 ft)
away.
Cleaning the Air Filters
Service Interval: After the first 250 hours (replace
them if they are torn or excessively
dirty).
1.
Remove the thumb screws and the grates from
the rear cab air filters
1. Filter
2. Grate
2.
Clean the filters by blowing clean, oil free,
compressed air through them.
Important:
Replace any damaged filters.
3.
Install the filters and grate, securing them with
the thumb screws.
22
(Figure
33).
Figure 33
3. Thumb screw
g302176

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 3300 series31990

Table of Contents