Husqvarna AUTOMOWER 430X Operator's Manual page 29

3. Follow guide wire
The default settings are set so that these 3
search options are combined to find the charging
station as fast as possible, but also with a
minimum risk of tracks forming on the lawn. The
product always starts by searching for the
Charging station signal . After a specified time
Follow guide and Follow
delay, it also uses
boundary wire .
Common causes why the product cannot follow
the wire are:
• Obstacles close to the wire have not been
isolated.
• The charging station, the boundary wire or
the guide wire is not installed in accordance
with the instructions in
charging station on page 20 , To install the
boundary wire on page 21 and in To install
the guide wire on page 21 .
To set the delay time for the guide wire and the
boundary wire
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station .
3. Use the right and left arrow buttons to select
Guide or Boundary.
4. Push the OK button.
5. Enter the time with the number buttons.
6. Push the BACK button.
To disable the guide wire and boundary wire
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Guide or
Boundary.
3. Use the arrow buttons to select
4. Push the OK button.
To test if the product can find the charging station
In the test the product follows the guide wire or
the boundary wire to the charing station.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Put the product 3 m / 9 ft. from the guide
wire or the boundary wire.
1201 - 001 - 05.06.2019
To install the
Installation
Installation
Disable .
3. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Guide or
Boundary > More .
4. Use the arrow buttons to select
Boundary .
5. Push the OK button.
6. Push the START button and close the hatch.
Make sure that the product follows the wire to the
charging station and that the product docks with
the charging station at first try.
To reset the settings for the guide wire and the
boundary wire
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Guide or
Boundary > More .
3. Use the arrow buttons to select
4. Push the OK button.
To change the signal range of the charging
station
For some installations it is necessary to decrease
the signal of the charging station. For example
when the charging station is put near a bush or
wall which prevents the product from docking
with the charging station.
Note: It is usually better to move the charging
station, than to decrease the range of the
charging station signal.
To get access to the menu
1. Do steps 1–3 in
on page 24 .
2. Use the arrow buttons and the OK button to
move through the menu structure
> Find the charging station > Charger .
3. Use the left arrow button to select
Min .
or
4. Push the BACK button.
3.10.7.3 Advanced
Corridor width
To set the corridor width
The boundary wire corridor is the area adjacent
to the boundary wire and the guide corridor is the
area adjacent to the guide wire. The product uses
the corridors to find the charging station. When
Installation
Guide or
Installation
Reset .
Installation
Max, Mid
Installation - 29