Husqvarna AUTOMOWER 430X Operator's Manual page 54

7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous
Goods Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package
and labels for commercial transportations,
including by third parties and forwarding
agents.
7.2 Storage
• Fully charge the product. Refer to
the battery on page 36 .
• Disconnect the product with the main switch.
To switch off the product on page
Refer to
36 .
• Clean the product. Refer to
product on page 38 .
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level
ground during storage, or use a Husqvarna
wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply
and all the connectors from the charging
station. Put the end of each connector wire
in a container with grease.
Note: If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
7.3 Disposal
• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the
battery, refer to To remove the battery on
page 54 .
7.3.1 To remove the battery
CAUTION: Only remove the battery
when you dispose the product. When
you remove the warranty seal, the
Husqvarna warranty is no longer
applicable.
54 - Transportation, storage and
disposal
1.
2.
3.
4.
To charge
Clean the
5.
6.
7.
8.
9.
10. Open the battery cover and remove the
Switch off the product. Refer to
on page 35 .
Pull out the grommet on the charging cable
at the very front of the product, and carefully
remove the connector.
Lift the cover, one corner at a time.
Remove the 14 screws with a Torx 20.
Lift the rear edge of the top section of the
chassis.
Disconnect the cable from the main circuit
board.
Remove the top section of the chassis.
Remove the 3 screws that holds the battery
with a Torx 20.
Disconnect the battery connection from the
main circuit board.
battery.
1201 - 001 - 05.06.2019
Main switch