Connecting The Device; Notes On Connection - Siemens SIMATIC IFP1200 Basic Operating Instructions Manual

Installing and connecting the device

3.3 Connecting the device

3.3 Connecting the device
3.3.1

Notes on connection

Requirement
• The device has been installed according to the information provided in these operating
instructions.
Connecting cables
Use copper cables at connectors with terminal connections
Use copper (Cu) cables for all supply lines that are connected to the device with terminals,
e.g. 24V DC power supply cables to the 24V DC power supply connectors.
Utiliser des câbles en cuivre sur les connexions à bornes
Utilisez des câbles en cuivre (Cu) pour tous les câbles d'alimentation qui sont raccordés à
l'appareil par des bornes, par exemple les câbles d'alimentation 24V CC sur le connecteur
d'alimentation 24V CC.
Connection sequence
Connect the device in the following sequence:
1. Earth connection (Page 33)
2. Power supply (Page 36)
Perform a power-up test to ensure the power supply is connected with the correct
polarity.
3. Connect the IFP Basic to a PC (Page 39) or connect the IFP1200 Basic C to a PC (Page 40).
4. I/O devices (Page 41), if needed
Note
Damage to the device
Failure to adhere to the connection sequence can damage the device.
Make sure you connect the device according to sequence listed above.
You disconnect the device in the reverse order.
32
CAUTION
Operating Instructions, 06/2023, A5E46178354 - AD
IFP Basic