Table of Contents
Advertisement
Connecting the cables
NOTICE
Observe local installation regulations
Observe the local installation guidelines and the local installation conditions, such as
protective wiring for power supply cables, when connecting the cables.
Short-circuit and overload protection
Different measures for short-circuit and overload protection are required when setting up an
entire plant. The type of components and the level of obligation for the protective measures
depends on the regulation that applies to your plant configuration.
• When connecting the cables, make sure that you do not bend the contact pins.
• Secure each cable connector with a cable tie.
• Provide adequate strain relief for all cables.
• The pin assignment of the ports is described in the technical specifications.
3.3.2
Earthing the device
The relevant symbol on the device identifies the terminal for the earth connection.
Requirement
• T20 screwdriver
• Cable lug for M4
• Protective conductor or equipotential-bonding cable with minimum cross-section 2.5 mm
IFP Basic
Operating Instructions, 06/2023, A5E46178354 - AD
Installing and connecting the device
3.3 Connecting the device
2
33
Advertisement
Table of Contents
