LG CBIZ2435B Owner's Manual page 12

INSTALLATION
12
from the holder), earth leakage trips and
contactors.
• The isolating switch must be easily accessible to
the customer with the hob installed.
• Consult local building authorities and by-laws if
in doubt regarding installation.
• Use heat-resistant and easy-to-clean finishes
(such as ceramic tiles) for the wall surfaces
surrounding the hob.
• The kitchen unit in which the appliance is fitted
must satisfy the stability requirements of DIN
68930.
After Installing the Hob
• Maker sure that the power cord is not accessible
through cupboard doors or drawers.
• Make sure that there is adequate flow of fresh air
from outside the cabinetry to the base of the
hob.
• If the hob is installed above a drawer or
cupboard space, a thermal protection barrier
must be installed below the base of the hob.
• The isolating switch must be easily accessible by
the customer.
Before Locating the Fixing Brackets
• The appliance should be placed on a stable,
smooth surface. Do not apply force onto the
buttons protruding from the hob.
Adjusting the Bracket Position
Fix the hob on the work surface by screwing 2
brackets on the bottom of hob(see picture) after
installation. Adjust the bracket position to suit the
particular work top thickness.
WARNING
• Under any circumstances, make sure that the
brackets cannot come into contact with the inner
surfaces of the worktop after installation.
CAUTION
• The hob must be installed by qualified
technicians. We have technicians available for
such service. Never carry out the installation by
yourself.
• The hob must not be installed directly above a
dishwasher, fridge, freezer, washing machine or
clothes dryer, as the humidity may damage the
hob.
• The hob shall be installed so that better heat
radiation can be ensured to enhance its
reliability.
• The wall and induced heating zone above the
installation surface shall withstand heat.
Connecting the hob to the mains
power supply
This hob must be connected to the mains power
supply only by a qualified electrician.
Before connecting the hob to the mains power
supply, check that:
• The domestic wiring system is suitable for the
power drawn by the hob.
• The voltage corresponds to the value given in
the rating plate.
• The power supply cable sections can withstand
the load specified on the rating plate.
Connect the hob to the mains power supply. Do not
use adapters, reducers, or branching devices, as
they can cause overheating and fire.
The power supply cable must not touch any hot
parts and must be positioned so that its
temperature will not exceed 75 ℃ at any point.
Check with an electrician whether the domestic
wiring system is suitable without alterations.