Table of Contents
Advertisement
How to deal with cooking failure
This time
It sends out sound during
use
With scent of plastic
and others
Some parts on plastic
spare parts are presented
in linear or wave shape
There is a gap between
upper housing and body
There is the scratch or dirt
on coating outside the
inner cooking pot
Tripping of circuit
breaker during cooking
Error display
Please pull out power plug (on the power supply side) from the socket, and dispose with the following method.
When there is the power outage
Continue the cooking or heat preservation after electrifying.
However, there may appear poor cooking, power supply cut-off, delay of appointed finishing time and other conditions.
It is the same as the condition when the power plug is pulled out halfway or circuit breaker trips.
Lithium batteries
The lithium batteries fixed in the body are used to drive the clock and memorize the cooking mode when pulling
out power plugs.
Lithium batteries are run down
Display disappears after the power plug is pulled out and it is impossible to memorize the time and cooking mode.
Insert power plug into socket, 12:00 will flicker after all lights turn on, and the cooker can be used
as usual.
(During cooking appointment, please adjust the clock to the current time before using)
Please consult with the store where you buy the electric cooker while changing batteries. (Charged)
Batteries are fixed in the body, and customers cannot replace by themselves.
Investigate the reasons (reference page)
Please refer to the "Sound in use" on Page 9.
When starting to use, there may be an odor, which will gradually disappear with the
use.Eliminate the unpleasant odor by ventilating and cleaning by boiling.
It is track of plastic, which is not a fault. It does not influence cooking or heat
preservation.
There will be gap more or less between upper housing and body, but the machine is
closed with the sealing ring.
As the using time increases, there will be scratch or dirt on coating on the outer side of
the inner cooking pot, which, however, will not influence cooking and heat preservation,
and the pot can be normally used.
In the case of being used together with other electric products, sometimes it may exceed
the rated current of the circuit breaker.
Please use a separate power socket.
Please check the causes once again for the COO error
Please clean up dust on suction port and exhaust port
at bottom of the body.
Please do not place the electric cooker on paper,
cloth, blanket, plastic bag or other soft items and use
it in places where suction port and exhaust port can
be easily blocked.
Please check whether there is an inner cooking port or
whether a non-dedicated inner cooking pot is used?
electric cooker.
Fault display of circuit board and sensor
Please promptly stop using, pull out power plug
and consult with retailers selling this product.
Please check before
applying for repair.
Restarting
Connect to power
cords after treatment.
Press
CANCEL
(Remove fault display)
Please re-start after the
inner cooking pot slot, inner
cooking pot and inner cover
are cooled down.
25
Advertisement
Table of Contents
