Husqvarna BMS 280P Operator's Manual page 13

WARNING:
The blades are very sharp.
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 16 .
4. Cut linear ditches in the floor. Make sure that the
distance between the ditches is the same as the
width of the long blade.
5. Install a long blade of the correct type. Refer to
Blades on page 26 and To replace the blade on
page 16 .
6. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 16 .
7. Remove the floor between the ditches.
Blade applications
Floor type
VCT – Tile (Vinyl Composition
Tile)
Vinyl-, Rubber, PVC, Direct
glued carpet
1998 - 001 - 03.07.2023
Use protective gloves.
To sharpen the
To sharpen the
Blade application
Do not use a blade wider than the dimension of the tile being removed. If the tiles do
not come up clean or the machine jumps on top of the tiles, install a smaller blade
until proper blade size is found or use a smaller portion of the blade.
The carpet must be scored down (ditching) with a 152mm Self-Scoring blade for
correct removal. Pre-scored carpet (ditched) or pre-cut carpet makes the machine
easier to control and blades stay sharp longer. Normally 254 mm blades are used
on direct glued carpet, secondary backed, unitary, double glued, vinyl foam, ure-
thane foam. Latex foams are easy to remove with a 305 mm blade.
Note:
Use a chisel and move the product in a fan
shape pattern to remove tiles and floors made of
wood.
13