Operation - Husqvarna BMS 280P Operator's Manual

product increases. Refer to the maintencance
instructions of the Operator's manual of the propane
tank.
• Clean the product to remove dangerous material
before you do the maintenance.
• Before you do the maintenance, do these steps:
• Turn the ON/OFF key to OFF and stop the flow
from the propane tank. Refer to
disconnect the propane tank on page 10 .
• Do the maintenance of the product on stable level
ground.
• Do not do modifications to the product. Modifications
that are not approved by the manufacturer can
cause serious injury or death.
• Replace damaged, worn or broken parts.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
To do before you operate the product
1. Read the operator's manual carefully and make sure
that you understand the instructions.
2. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
3. Do daily maintenance. Refer to
schedule on page 14 .
4. Make sure that the product is assembled correctly
and is not damaged.
5. Do a check of the control panel. Make sure there are
no faults or damages.
6. Make sure that only approved persons are in the
work area.
7. Put the product on the work area. Make sure that the
transportation of the product to and in the work area
is done safely and correctly. Refer to
on page 22 .
8. Install a tool. Refer to
dimension and installation position on page 9 .
Make sure that the tool has the correct angle and
pitch for the operation.
9. Make sure that the blade is sharp. If it is necessary,
replace or sharpen the blade. Refer to
the blade on page 16 and To replace the blade on
page 16 .
1998 - 001 - 03.07.2023
To connect and
Before you operate the
Maintenance
Transportation
To select the correct blade
To sharpen
• Always use original accessories and spare parts.
Accessories and spare parts that are not approved
by the manufacturer, can cause serious injury or
death.
• Let an approved service agent do servicing on the
product regularly.
• Installation and repair of the supply system for
propane must be done only by approved servicing
personnel for propane systems.
• Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
• Do the inspection and/or maintenance with the
engine stopped.

Operation

10. If you use a self-scoring blade, make sure that the
angles at the ends of the blade (A) are sharp.
A
To select the correct blade dimension
and installation position
WARNING:
blades are very sharp.
All available blade types can be used for their approved
materials: hardwood, ceramics, linoleum, vinyl, carpet,
adhesives and glue. Refer to
It is necessary to select correct dimension and
installation of the blade for the material to remove and
the subfloor type. Blades of different dimension can be
necessary during the same work operation.
• Select a blade of smaller dimension in these
situations:
a) At the start of an operation.
b) Operation on materials with strong adhesive.
c) Operation on hard materials.
• Select a blade of wider dimension in these
situations:
a) Operation on soft materials.
A
Use protective gloves. The
Accessories on page 26 .
9