Sharp PN-ZB03W Operation Manual page 29

Network Host Name
Setup and Domain
Name
IP Setup
DHCP Server
Setup
GateKeeper
Host Name
Set the host name of the wireless board.
To use the same name as the SSID, select the "Same as WLAN Network name" checkbox.
This checkbox should normally be selected. If not selected, the wireless board will only
operate properly in the DNS environment that corresponds to the set host name.
Domain Name
Set the domain name of the wireless board.
Obtain an IP address automatically
If the network has a DHCP server, set the IP address, subnet mask, default gateway, and
DNS Server automatically.
Use the following IP address
Set the IP address, subnet mask, default gateway, and DNS Server manually.
Auto
Use the DHCP server function of the wireless board.
Start IP / End IP:
Specify the range of IP addresses assigned to clients by the wireless board's DHCP
server.
Subnet Mask / Default Gateway / DNS Server:
Specify the addresses that the wireless board's DHCP server sets in the client.
Disable
Do not use the DHCP server function of the wireless board.
You can limit access to the wired LAN from computers connected to the wireless board by
wireless LAN.
All Pass: Allow all access to the wired LAN.
All Blocked: Block all access to the wired LAN.
Internet Only: Only allow access by web browser.
29
E