Bosch JLR-100-069 Original Instructions Manual page 22

en-gb | 24 | JLR-100-069
15. If necessary, turn the spindles (27) to tilt the
platforms (3) and (4).
WARNING
Tipping Scissors Lift Table!
If the load is distributed unevenly, the scissors lift
table could tip over. This could result in serious
personal injuries or severe damage to materials.
Ensure that the platforms are not tilted more
than 2°.
There are several ways to turn the spindles (27):
Turn the spindles (27) with a 3/8 inch wrench.
Turn the spindles (27) with an open-end or
combination wrench, wrench size 21.
Turn the spindles (27) with a cordless
screwdriver.
Figure 25: Tilting the Platforms
4 Platform (extendible)
27 Spindles (2 pieces)
16. If necessary, attach the required adaptors to the
scissors lift table (see the workshop manual of
the automobile manufacturer).
SP04006297 | 06/2021
WARNING
Danger of Falling Loads!
The load could tip or fall if the accessories have
not been attached to the lifting equipment
correctly or if the load has not been attached to
the accessories correctly. This could result in
serious personal injuries or severe damage to
materials.
Ensure that the accessories have been
secured to the lifting equipment correctly.
Ensure that the load has been secured to the
accessories correctly.
There are M10 threaded holes on top of the
platforms for screws. Tighten the screws in
these holes with a torque of up to 47 Nm.
There are holes in the sides of the platforms
for adaptors or support straps.
Figure 26: Platforms
31 M10 Threaded Holes on Top of the Platforms
32 Holes in the Sides of the Platforms
17. Position the vehicle part on the scissors lift table
so that it is flat or position the vehicle part on the
required adaptors (see the automobile
manufacturer's workshop manual for
specifications on how to attach the vehicle part
to the scissors lift table).
18. If necessary, select the required restraints, such
as chains, tightening straps, support straps, or
hooks, to secure the vehicle part to the scissors
lift table. Select suitable restraints for the shape
of the vehicle part and in accordance with the
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany