Safety; General Safety Instructions - Bosch JLR-100-069 Original Instructions Manual

en-gb | 10 | JLR-100-069

2 Safety

2.1

General Safety Instructions

WARNING
Read and follow all safety notes and instructions!
Failure to follow the safety instructions could result in
serious injuries and severe damage to materials.
Observe and follow the safety notes below.
The lifting equipment has been specifically
constructed for its intended use. The safety of the
lifting equipment can no longer be ensured if it is
misused or modified in ways not expressly
approved by the manufacturer. Serious personal
injuries or severe damage to materials could occur.
Ensure that each person using the lifting
equipment is familiar with these instructions and
can access them at all times.
Ensure that all users are also familiar with the
instructions for additional special tools and
equipment that are required for the repair work.
Read and follow the automobile manufacturer's
workshop manual carefully.
Use the lifting equipment only for work that has
been expressly approved by the automobile
manufacturer.
Do not climb on the lifting equipment.
Do not use the lifting equipment to lift persons or
animals.
Use the lifting equipment only to support and lift
vehicle parts, never an entire vehicle.
Wear safety shoes that meet the ISO 20345, S2
standard.
Wear safety gloves that meet the EN 388 standard.
Position hands and feet so as to avoid potential
crushing hazards.
Do not exceed the maximum load capacities
specified in these instructions, neither for the
entire scissors lift table, nor for the extended
platform.
To be used only by persons in good physical
condition.
Use only with the help of an assistant.
Ensure that the load centre is in the middle of the
scissors lift table.
Ensure that the load remains stable and will not tip
on the scissors lift table.
Ensure that the path remains clear and easily visible.
SP04006297 | 06/2021
Move the scissors lift table with loads on it only
when the platforms are in the lowest possible
position.
Move the scissors lift table on ground that is as
even as possible. Do not move the scissors lift
table over slopes above 3.5°, with the exception of
the ramp included in delivery.
Move the scissors lift table on ground that is as
even as possible. Do not move the scissors lift
table over slopes above 2° when loads are on it.
Do not move the scissors lift table at a speed
faster than 4 km/h.
Do not work underneath loads.
Perform work only at an ergonomic height.
Use the scissors lift table only with the protective
bellows in place.
Put loads on the platforms at angles of only up to
2°.
Ensure that the filler plug is unscrewed slightly to
raise and lower the platforms. Re-tighten the filler
plug to transport the scissors lift table over longer
distances.
Place the forklift forks to lift the scissors lift table
only between the forklift signs on the bottom frame.
Bosch Automotive Service Solutions GmbH
Am Dörrenhof 1
85131 Pollenfeld-Preith
Germany