Table of Contents
Advertisement
Chapter 1 Installing Windows
9.
In Paging file size for each drive, enter the value equal or larger than the recommended value for Initial
size, and the value larger than Initial size for Maximum size, and then click Set.
Note the following when specifying a paging file size:
The paging file is used to collect debug information (dump file). The boot volume must have a paging
file of its initial size ("total size of physical memory" + 400 MB (total size of physical memory + 1,100
MB when the total size is 4 TB or more) or more) is enough to store the dump file. Make sure to specify
a sufficient paging file size. Recommended size: "the installed memory size" x1.5 or more
See "System Partition" in Chapter 1 (3.1 Precautions of Windows Server 2016 Installation) for
recommended value.
When DIMM is added, re-specify the paging file according to the increased memory size.
10. Click OK.
If a message to restart Windows appears, restart the system according to on-screen message.
Specification of the memory dump settings is now complete.
78
Installation Guide (Windows Server 2016)
4. Setting up for Maintenance
Advertisement
Table of Contents
