TROUBLESHOOTING
Message
Sequence Type
Must be None
When Editing!
No Database
Found!
No Data!
Bar Code Error!
Memory Full!
Reduce File Size
to Proceed
Hi-Res Print Not
Supported with
This Media!
58
Error Messages
Text cannot be edited when you set Sequence Type in PUNCH-
DOWN BLOCK to Horizontal or Backbone.
The Database key on the P-touch labeling system was pressed while
there is no database file saved in the P-touch labeling system.
You tried to open a database file which doesn't contain any data.
Bar code labels were attempted to print from a database.
The P-touch labeling system will display this message when the
selected range of the database includes invalid characters/numbers
not supported by the bar code protocol.
The total data size exceeds the built-in flash memory after editing
database records.
Cannot print labels in high resolution mode when non-supported
media (fabric tape, heat shrink tube etc.) is installed in the P-touch
labeling system.
Cause/Remedy