Table of Contents
Advertisement
EDITING A LABEL
PUNCH-DOWN BLOCK
Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up to three lines for each block on a single label and you can
enter three lines for each block. In this mode, you can specify the following items:
• Module Width: 8.0" (200 mm), 2.0" (50 mm) - 12.0" (300 mm)
• Block Type: 4 Pairs, 2 Pairs, 3 Pairs, 5 Pairs, Blank
• Sequence Type:
• Start Value: ---, 1 - 99999
• When "Blank" is selected in "Block Type", "Sequence Type" is set to None.
• When None is selected in "Sequence Type", "Start Value" shows "---" and you
cannot set a value. Selecting Horizontal or Backbone however, allows you to set
the "Start Value" from 1 to 99999.
Heat Shrink Tube
When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen
is displayed when any of the labeling application type keys are pressed.
• Label length: Auto, 1.0" (25 mm) - 39.0" (999 mm)
However, the maximum printing length is 19.6" (500 mm) when using
Heat Shrink Tube with a width of 0.23" (5.8 mm) or 0.34" (8.8 mm).
Text: Type in single or multiple lines of data
When using Heat Shrink Tube:
• You cannot print frames.
• Portions of some decorative characters may be cut off when a line is broken.
• The printed characters may be smaller than when using TZe tape.
Setting Cross-ID
When printing Cross-ID labels, use the Cable Wrap and Cable Flag keys.
1
Press the Cable Wrap or Cable Flag key.
2
Select "Cross-ID" using the
3
Select "On" or "Cross-ID" by using the
4
1 line: Enter the text and insert "/" or "\" where you want to apply Cross-ID.
2 or more lines: To apply the Cross-ID layout, press the Enter key to create another line.
For example:
6
Selecting a Labeling Application Type
(None),
or
key.
1 line
(Horizontal),
or
key.
2 or more lines
(Backbone)
Advertisement
Table of Contents
