Table of Contents
Advertisement
7.
Install the spark-plug wire.
8.
Repeat steps
1
through
plug.
Adjusting the High/Low Idle
1.
Lift the cargo bed and secure it with the prop rod.
2.
At the throttle cable housing, loosen the forward
jam nut and tighten the rear jam nut to increase
the low idle
(Figure
Figure 46
1. Throttle cable housing
2. Jam nuts
3.
Test the high idle with a tachometer:
A.
Ensure that the shift lever is in the N
position.
B.
Start the engine.
C.
Fully depress the accelerator pedal
and measure the engine speed with a
tachometer; the engine speed should be
between 3650 to 3750 rpm. If it is not, shut
off the engine and adjust the cable jam nuts.
Important:
Test with a tachometer to ensure that the
high idle is between 3650 to 3750 rpm.
4.
Lower and secure the cargo bed.
7
for the other spark
46).
3. Throttle lever
Do not lower the high idle.
Fuel System
Maintenance
Inspecting Fuel Lines and
Connections
Service Interval: Every 400 hours/Yearly (whichever
Inspect the fuel lines, fittings, and clamps for signs of
leaking, deterioration, damage, or loose connections.
Note:
Repair any damaged or leaking fuel system
component before using the machine.
Replacing the Fuel Filter
Service Interval: Every 400 hours/Yearly (whichever
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key.
4.
Raise the bed and support it with the prop rod.
g229954
5.
Disconnect the battery; refer to
the Battery (page
6.
Place a clean container under the fuel filter and
replace the fuel filter as shown in
EUTRAL
40
comes first)
comes first)
Disconnecting
42).
Figure
47.
Advertisement
Table of Contents
