Table of Contents
Advertisement
a. Hold the upper edge of the lter with both
hands. Gently turn and lift until the upper edge
is free from the wire rope.
b. Lift the lter and move it forward slightly until
the lter is separated from the 4 wire ropes.
c. Move the lter to the right until it is separated
from the air grille , and then the lter can be
taken out.
b
Model B
1. Press the circular positon to open the two
screw covers, then remove the two screws.
Screw Cover
2.Hold and open the air grille, then take out the
air lter.
3. Clean the air lter
Dusts will accumulate on the lter along with
the unit operation, and need to be removed from
the lter,or the unit would not function e ectively.
Clean the lter every two weeks when you use
the unit regularly.
Clean the air lter with a vacuum cleaner or
water.
a
c
4. Re-install the air lter.
5. Press "UP" button on the remote controller to
reset the air grille. (Applicable to model A)
Re-install the air grille by xing the two screws
and close the two screw covers.
(Applicable to model B)
air lter
a. The air intake side should face up when using
a vacuum cleaner.
b. The air intake side should face down when
using clean water.
For excessive dusts, use a soft brush and natural
detergent to clean it and dry in a cool place.
CAUTION
• Do not dry out the air lter under direct
sunshine or with re.
• The air lter should be installed before the
unit body installation.
Page 13
Advertisement
Table of Contents
