Assembly And Setup - Hitachi StarBoard Link EZ2 User Manual

StarBoard Link EZ2

2. Assembly and Setup

Be sure to follow the precautions below when installing the StarBoard.
Important
Use on a flat surface.
This product is designed so that stable input is achieved when used on a flat surface.
Do not use on an uneven or curved surface.
WARNINGS
Install this product on a vertical surface.
Do not install on a slanted surface or ceiling. Failure to comply may cause the stand
to fall, resulting in personal injury, or may cause damage to this product due to shock
of impact from the board falling.
If magnets are not used to install this product, fix it in place with screws.
Failure to comply may cause the stand to fall, resulting in personal injury, or may
cause damage to this product due to shock of impact from the board falling.
NOTICE
- Select a level and stable position.
- Do not set it up near equipment that might generate electromagnetic waves or
radio frequencies, such as radio transmitters, televisions, copying machines or air
conditioners.
- Avoid locations that are dusty, that are subject to extremely high or low
temperatures or humidity, or that are exposed to direct sunlight.
2-1
Assembly and Setup
English