Table of Contents
Advertisement
StarBoard Link EZ2
[4] "Adjustment completed" will be shown after sensor adjustment. Press "OK" to close the
dialog.
If an error such as the following appears, click the "OK" button and then perform adjustment
again while referring to Section 2.3.5. If adjustment is still not successful, the StarBoard unit
may be defective.
[5] If adjustment was successful, click the "Exit" button.
* Note that just clicking the button does not complete the adjustment process.
[6] To save the adjustment result, click the "Yes" button.
This completes sensor adjustment.
2-13
Assembly and Setup
English
Advertisement
Table of Contents
