Table of Contents
Advertisement
StarBoard Link EZ2
2.3.2 Installing the Reflective Bars
(1) Attach the reflective bars to the bottom side of the installation surface in accordance with the
width of the projection area. Attach so that the silver surface of the reflective bars is facing inwards,
and so there are no gaps.
(2) The bottom of left and right reflective bar attach to get to the bottom surface of the projection
area.
(3) Attach the reflective bars so that the higher part can cover 5 inches (1 digitizer height and 2
inches) of space above the top edge of the projection area.
13cm (5 inches)
(3)
(2)
Projection Area
(1)
* Make sure the silver surfaces of
the reflective bars being connected
by their corners.
Reflective Bar
2-4
Assembly and Setup
*Length of the reflective
bars can be adjusted.
English
Advertisement
Table of Contents
