Hitachi PC-ARFG2-Z Installation & Maintenance Manual page 48

25. ESP Setting
Step3. Press " "or " " to select the setting and press "OK"
to confirm the setting.
Step4. Press " " to return to Step2 screen. Pressing " ", " ",
" ", or " " and press "OK" to set another indoor unit,
or press" " again to return to ESP Setting screen.
NOTES:
•
ESP Standard setting is the same as C5 of function selection.
•
When changing C5 of function selection, the change is valid immediately if ESP setting is standard mode.
Otherwise, the change will not be valid until ESP setting is changed to standard mode.
3. ESP Auto Setting
Step1. Select "ESP Auto Setting" on the ESP Setting screen
and press "OK".
Step2. Select the indoor unit by pressing " ", " ", " ", or " "
and press "OK".
(This screen is NOT displayed when only one indoor unit
is connected with the controller. In this case, Step3 is
displayed.)
Step3. Select "Yes" and press "OK" to start auto ESP.
Step4. In Checking ESP screen,
a. wait for the "Completed" screen shows,
select "Continue" and return to Step 2 to select
another indoor unit for auto ESP. Or select "Complete"
to return to Step1.
A16381H9HF
ESP Standard Setting
Standard
Hi speed 1
Hi speed 2
Select
OK
ESP Setting
ESP Standard Setting
ESP Auto Setting
ESP Manual Setting
Display ESP Setting
Select
OK
ESP Auto Setting
ALL
01-00
01-01
01-02
01-03
OK Enter
ESP Auto Setting
All
Start Auto ESP now?
Yes Cancel
Select
OK
ESP Auto Setting
Checking ESP
OK Abort
ESP Auto Setting
Completed.
Continue Complete
Select
OK
Back
Back
Back
Back
Back
Back
45