Hitachi PC-ARFG2-Z Installation & Maintenance Manual page 7

2. Installation Work
This manual is applied for common use of the wired remote controller(connnected in non-zoning or zoning
system). Refer to "Installation Work" of INSTALLATION & MAINTENANCE MANUAL of Premium Zoning Kit when
connected in Zoning system.
[Before Installation]
(1) This packing contains the following parts.
Name
Appearance
Qty.
(2) When installing two controllers one above the other, allow a gap of at least
50mm between the two.
[Installation Procedures]
(1) Insert the edge of the slotted screwdriver into the groove at the bottom of the holding bracket, push and turn
the slotted screwdriver to separate and remove the controller from the mounting plate.
NOTE:
•
Do not insert the slotted screwdriver into the tab beside the groove. The tab may be damaged and the
advanced color wired remote controller cannot be installed.
4
PC-ARFG2-Z
Operation Manual
1
Groove Part
Installation & Maintenance
1
Slotted
Screwdriver
Figure Seen from Bottom Side
Mounting Plate
Tabs for Attaching Controller
2. Installation Work
Screw
Manual
M4 × 16mm
1
more than 50mm
Approx. 6mm
2
A16381H9HF