Storage; Storage Safety; Storing The Machine - Toro 58610 Operator's Manual

Walk-behind edger
Table of Contents

Advertisement

Storage

Storage Safety

Always shut off the machine, wait for all moving
parts to stop, and allow the machine to cool before
adjusting, servicing, cleaning, or storing it.
Never store the machine with fuel in the tank
inside a building where fumes may reach an open
flame or spark.

Storing the Machine

1.
Park the machine on a level surface, shut off
the engine, and wait for all moving parts to stop
before leaving the operating position.
2.
Remove debris from the machine and engine.
Important:
You can wash the machine
with mild detergent and water. Do not
pressure-wash the machine. Avoid
excessive use of water, especially near the
engine and transmission.
3.
Service the air cleaner; refer to
Cleaner (page
18).
4.
Change the engine oil; refer to
Engine Oil (page
5.
Prepare the machine for storage for over
30 days as follows:
A.
Add fuel stabilizer/conditioner to fresh fuel
in the tank. Follow mixing instructions from
the fuel stabilizer manufacturer. Do not
use an alcohol-based stabilizer (ethanol or
methanol).
B.
Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C.
Shut off the engine, allow it to cool, and
drain the fuel tank.
D.
Start the engine and run it until it shuts off.
E.
Dispose of fuel properly. Recycle the fuel
according to local codes.
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
6.
Remove and check the condition of the spark
plug; refer to
Servicing the Spark Plug (page
With the spark plug removed from the engine,
pour 15 ml (1 tablespoon) of engine oil into the
spark plug hole. Install the spark plug and pull
the recoil rope 3 times to coat the cylinder with
oil. Do not install the wire on the spark plug.
Servicing the Air
Changing the
19).
Do not store fuel containing
7.
Check and tighten all fasteners. Repair or
replace any part that is damaged.
8.
Paint all scratched or bare metal surfaces. Paint
is available from your Authorized Service Dealer.
9.
Store the machine in an upright position in a
clean, dry garage or storage area. Keep it out
of reach of children or other unauthorized users.
Cover the machine to protect it and keep it clean.
19).
22

Advertisement

Table of Contents
loading

Table of Contents