Assemble The Cutting Head - Toro 58610 Operator's Manual

2

Assemble the Cutting Head

Parts needed for this procedure:
1 Cutting head assembly
1 Pivot rod
1 Bracket
1 Bolt (M8 x 20 mm)
1 Nut (M8)
4 Hairpin cotter
Procedure
1. Remove the engine shroud covering the pulley.
1. Shroud
Figure 5
2. Bolt—M5 x 12 mm (2)
2. Install the pivot rod and hairpin cotter.
1. Hairpin cotter
3. Push the pivot rod as far left as possible.
4. Install the belt from the cutter head onto the
engine pulley.
5. Slide the cutter head onto the pivot rod and
secure it to the rod and frame.
Note:
You may tip the machine on its right side
to aid in the assembly.
g383691
1. Nut (M8)
2. Cutter head
3. Belt
6. Install the engine shroud as shown in
8
Figure 6
2. Pivot rod
Figure 7
4. Bolt (M8 x 20 mm)
5. Hairpin cotter
6. Support racket
Figure
g383689
g383690
5.