Handling And Operation; Before Initial Use; Operation - Silvercrest 331466 1907 Operating Instructions Manual

Handling and operation

This section provides you with important information on handling and using the
appliance.

Before initial use

♦ Clean all accessories as described in the section "Cleaning and care" to
remove any possible production residues.
♦ Read these operating instructions carefully.
♦ Set up the appliance in accordance with the safety instructions.
♦ Open the safety catch
the position.
♦ Clean the appliance with a damp cloth as described in "Cleaning and Care".
♦ Close the appliance.
♦ Insert the mains cable plug
power socket which supplies the voltage stated in the"Technical data" section.
Allow the appliance to heat up for about 5 minutes on the maximum temperature
setting by turning the heat level control
NOTE
► The first time the appliance heats up, a small amount of smoke and odour
may be generated due to production-related residue. This is normal and is
completely harmless. Provide sufficient ventilation; for example, by opening
a window.
♦ After heating, pull the plug
cool down completely.
♦ Clean the appliance again with a damp cloth.

Operation

♦ Close the appliance lid using the handle
♦ Slide the fat collector tray
♦ Replace the plug
mains power socket. The green control lamp "Ready"
level control
setting.
♦ Set the desired level on the heat level control
goes out and the red "Power" control light
level has been reached, the red "Power" control light
"Ready" control lamp
SPM 2000 D2
by moving the slider from the
in a properly connected and earthed mains
out of the mains socket and allow the appliance to
into the appliance.
in the mains mains power socket. Replace the plug in the
is set to "MIN" or lower. The appliance does not heat up in this
lights up again.
position to
as far as the right-hand stop.
.
lights up when the heat
. The green "Ready" control lamp
lights up. As soon as the set heating
goes out and the green
GB │ IE │ NI │ CY
│
9 ■