Step 1. Disassemble Existing Ac Connections; Step 2. Disassemble Ac Panel And Central Panel; Figure 5 Disassemble Ac Connection; Figure 6 Ac Panel Removed - ABB G391 Series Quick Start Manual

Edge ac short circuit current limiter
Table of Contents

Advertisement

QUICK START GUIDE

Step 1. Disassemble existing AC connections

Use "Turn off/Lock Out Tag Out".
1.
Turn off AC power supplying the Edge cabinet.
2. Note which cord is "A" feed and which is "B" feed.
3. Unplug AC cords from the twist-n-lock input receptacles
at the top of the cabinet.
Note: This process is written for a system that is not
providing active load support or that can be
temporarily taken down. If this system is live and
cannot be taken down for the installation duration
period please contact Technical Support to discuss
alternatives.

Step 2. Disassemble AC panel and central panel

1.
Remove the 4 screws which attach the AC input
panel to top of the cabinet so that the panel can be
opened as shown.
2. Disconnect the black, blue and red wires from each
of the receptacles. Keep track of the wire which is
connected to "A" and "B" receptacles.
3. Remove the 4 screws on the back center panel and
then remove the panel.
Note: Both the AC input panel and the back center panel
will be discarded.
Page 9
© 2023 ABB. All rights reserved.
Edge_Ilim_G391_QSG

Figure 5 Disassemble AC connection

Figure 6 AC panel removed

Figure 7 Central panel removed

Version. 2.0

Advertisement

Table of Contents
loading

This manual is also suitable for:

Edgecabg3911600481709a

Table of Contents