Dell DIGIRAD N Operating Instructions And Warnings page 17

6.6 Adding Access Codes (Direct Access Mode)
If a code is memorized in "direct access" mode, that code can activate the associated radio channel at each entry. Simply activate the
numeric keypad and enter the code without any other confi rmation key, the radio command will be sent immediately.
MEMORIZATION PROCEDURE:
Example of adding single code 5555 on channel CH1
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 1 E + 1 E + 1 E + 5555 E + 1 E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
Example of adding code 6666 on channel CH2 and code 7777 on channel CH3 in sequence
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 1 E + 1 E + 1 E + 6666 E + 2 E
• Wait for the green LEDs to turn off
• Enter 7777 E + 3 E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
In case of error (red LEDs): The code you tried to memorize may already be stored (it is not possible to use the same code twice) or the
typing was incorrect. Try to repeat the operation.
USAGE:
Activate the keypad by pressing any key and then enter a valid code: the radio command will be sent. To resend the command, you will
need to re-type the associated code.
6.7 Adding Access Codes (Multiple Access Mode)
If a code is memorized in "multiple access" mode, that code can activate, within a certain time (command time-out), one or more radio
channels, even repeatedly, without having to be re-entered each time.
WARNING: a code already stored in "direct access" mode cannot be memorized also in "multiple access" mode and vice versa.
MEMORIZATION PROCEDURE:
Example of adding single code 8888 on channel CH1
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 1 E + 2 E + 1 E + 8888 E + 1 E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
Example of adding multiple code 9999 on channels CH1, CH2 and CH4
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 1 E + 2 E + 1 E + 9999 E + 1 2 4 E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
In case of error (red LEDs): The code you tried to memorize may already be stored (it is not possible to use the same code twice) or the
typing was incorrect. Try to repeat the operation.
USAGE:
Activate the keypad by pressing any key and then enter a valid code: within the time defi ned by the command timeout (see paragraph
7.5), press one of the keys corresponding to the radio channels associated with that code (1, 2, 3 or 4), even more times depending on
the radio channel you want to activate.
DIGIRAD N
15