Dell DIGIRAD N Operating Instructions And Warnings page 20

DIGIRAD N
7.6 Code length
You can adjust the length of the codes that you will have to enter to control the paired devices.
Code length change (DEFAULT: 4 digits)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 6 E + from 2 to 8 (enter the desired value) + E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
Normally the length of the access codes is defi ned at the beginning of the installation.
If there is a need to change the length of the codes after installation, and there are codes already stored, these will only work if the new
length set is greater, in which case the user will simply have to add one or more 0s (zero) at the end of the code to be entered (e.g.
stored code 1234, new length set to 6, the code to type to activate the command will be 123400).
WARNING: If the new code length set is shorter, for security reasons all previously memorized codes will be reset and the codes will have
to be learned again.
7.7 Sound feedback
You can turn off the keypad sound feedback.
Sound feedback change (DEFAULT: 1 ON)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 7 E +
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
7.8 Reset
If there is a need to reset the data stored on DIGIRAD N, 2 options are available:
- Reset of the settings only: resets the settings to the default values and deletes the installer code (if set);
- Total reset: resets the settings to the default values, deletes the installer code (if set) and deletes ALL stored access codes.
WARNING: At the end of a total reset, for safety reasons, the internal radio serial number of DIGIRAD N is also automatically changed,
to prevent an ill-intentioned person from using the selector to control the paired system devices. After changing the radio serial number,
DIGIRAD N must necessarily be paired again on the control unit or on the receiver in use.
Reset of the settings only
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 8 E + 1 + E for 5s until the end of the long beep
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
Total reset
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 8 E + 2 + E for 5s until the end of the long beep
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
If a previously set installer code is lost, access to DIGIRAD N programming will be denied. In this case, it will still be possible to perform
a total reset of the device but it will be necessary to access the batteries by following the steps below:
Total reset with access to the BATTERIES
• Remove DIGIRAD N from the wall by unscrewing the special screw on the bottom;
• Activate the keypad to make sure you exit stand-by mode;
• Remove the BT2 battery (Fig. 8);
• Reinsert the battery in the housing;
• Press and hold down keys C + 0 + E at the same time and wait for the long beep (about 5s);
• The turning off of the green LEDs will confi rm the success of the operation;
• Reassemble DIGIRAD N on the wall.
18
1 (ON)
+ E
2 (OFF)