Dell DIGIRAD N Operating Instructions And Warnings page 19

7 SETTINGS
DIGIRAD N settings can be confi gured to suit the needs of the installation site.
7.1 Radio coding
There are 3 radio codings available.
Radio coding change (DEFAULT: 1 HCS Rolling Code)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
1 (HCS Rolling Code)
2 (Dip-Switch)
• Enter 9 E + 1 E +
3 (D.A.R.T.)
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
Normally the radio coding is defi ned at the beginning of the installation. However, if there is a need to change the radio coding after
installation, any previously stored codes will continue to work correctly.
In any case, DIGIRAD N must be memorized again on the control unit or on the receiver (see paragraph 6.3).
7.2 Backlight logic
For the backlight of the numeric keypad, there are 2 options available:
- Always OFF (Key LEDs always off);
- ON with low light (Key LEDs lit only in low light conditions and for a defi ned maximum time (see paragraph 7.4);
Backlight logic change (DEFAULT: 2 ON with low light)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
1 (Always OFF)
• Enter 9 E + 2 E +
2 (ON with low light)
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
The status LEDs on the top will always be active regardless of the option selected.
7.3 Backlight intensity level
You can adjust the backlight intensity level. ATTENTION! increasing the intensity level will cause a greater consumption of the batteries
and consequently will reduce the life of the batteries themselves.
Backlight intensity level change (DEFAULT: 1 minimum)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
1 (Minimum)
• Enter 9 E + 3 E + 3 (Average)
5 (Maximum)
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
7.4 Backlight time-out
You can adjust the time after which the key LEDs turn off after a key is pressed. ATTENTION! increasing the duration will cause a greater
consumption of the batteries and consequently will reduce the life of the batteries themselves.
Backlight time-out change (DEFAULT: 3s)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 4 E + from 1 to 255 (enter the desired seconds) + E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
7.5 Command time-out
You can adjust the time within which a command can be sent after entering a valid access code in multiple access mode. Pressing any
key will reload the time-out.
Command time-out change (DEFAULT: 5s)
• Activate the keypad and enter programming mode (keys 1 and 3 for 5s)
• Enter 9 E + 5 E + from 1 to 255 (enter the desired seconds) + E
• Wait for the green LEDs to turn off
• Exit programming mode (C key for 5s)
+ E
+ E
2 (Low)
4 (High) + E
DIGIRAD N
17