Adjustment Items - Pioneer DEQ-9200 Owner's Manual

4. Press (4) or (¥) side of buttons [6] to
select a speaker unit.
Each time (4) or (W) side of buttons [6]
is pressed, the selected speaker unit
changes.
(Numeric display [17] shows
"0 — 400 CM" or "0 — 160 INCH".)
Note:
* Incase you use only one sub-woofer in
monaural, enter the identical distance
for "LOW-R" and "LOW-L".
18
Adjusting Network
The network function built into this unit
divides audio signal into frequency ranges
so that each range can be reproduced
though the exclusive speaker unit for that
range.
Adjustment Items
The adjustments possible with the network
function are as follows. Adjust the
following items according to the reproduce
frequency bands and properties of the
speaker units.
f
Level (dB)
@ Reproduce frequency band
: l :
eae cats
® Slope (dB/oct.)
20 ~=—- 100 i 1k Frequency —
Ao Mm (Hz)
Cutoff frequency Cutoff frequency
of HPF of LPF
@ Reproduce Frequency Band
speaker unit can be set by adjusting the
cutoff frequencies of the high-pass filter
(HPF) and low-pass filter (LPF).
* The HPF is a filter which passes high
frequencies by cutting off the lower
frequencies (range) than the set
frequency.
* The LPF is a filter which passes low
frequencies by cutting off the higher
frequencies (range) than the set
frequency.
Adjustable filters
| PRO)
Sub-woofer LPF
MID1 Middle/bass speaker HPF
F5 MID2 Middle/bass speaker LPF
HIGH High-range speaker HPF
STD
Front speaker HPF
| Fs | oR | Rear speaker HPF
Subwoofer LPF