Table of Contents
Advertisement
. Press button [7] to select the position
where the microphone is installed.
(Refer to "Setting the Listening
Position" on page 31.)
=
2
a
"
~UNOE
WH
uno:
. Press one of (F1) to (F3) buttons [9] to
select the desired acoustic property.
(Refer to "Selectable acoustic
properties" on page 22.)
equalization.
(The "START" display frame [22] lights
and "AUTO EQ" [19] blinks.)
11.A 10-second countdown starts. Get off
the car and close the doors in less than
10 seconds.
The auto-equalizing (measurement and
compensation of acoustic property)
starts and the measurement tone
(noise) is output from each speaker.
*
To cancel the auto-equalizing in the
middle, press button [2].
12.When the auto-equalization is
completed, the created equalizer curve
is displayed.
(The "START" display frame [22] goes
out and "AUTO EQ" [19] lights.)
ASD
eee
a Fe
coe
5
==
eeeesseeesee
;
aaa
|
'
'an
rea
Mata.
BAD
*
Maver
«
Incase this unit fails to measure
normally the acoustic property in the
car compartment,
measurement tone
sounds repeatedly and an error code
(example: AEQ Err E 2) is displayed. In
this case, check the error content by
referring to "Error Codes of Auto-
equalizing Function" on page 27.
13. G9) Fine-adjust the created auto-
equalizer curve.
In PRO mode, the user can fine-adjust
the created auto-equalizer curve.
For the operating procedure, refer to
"Fine adjustment of Auto-equalizer
curve" on next page.
14.Press button [2] to quit auto-
equalization mode.
When the auto-equalization is
completed, the auto-equalizer is
switched on (with "AUTO EQ" lighted
[19]) automatically and the
compensation with the auto-equalizer
curve is applied to the output sound.
15.Remove the microphone and belt from
their installed position and retain them
Retain the microphone and belt
carefully in the glove box, etc. Do not
leave them under direct sunlight for
long hours, for the high temperature
may cause deformation, discoloration
or damage to them.
25
Advertisement
Table of Contents
