Table of Contents
Advertisement
Parts Identification
Fig. 1
[4]
Mode shift button
[5]
Frequency up/down buttons
[6]
Level up/down buttons
[9]
Function buttons
(F1) Slope selector
(F2) Phase selector
(F3) LOW
Gaz
(F4) MID 1 Giza /F
(F5) MID 2 Gxa /R
(F6) HIGH
GO /SW em
[11] Display selector button
Fig. 3
[15] Operation display
[17] Numeric display
[18] Phase reverse indicator
[22] Function indicators
Adjusting Network
1. Press button [4] to switch to network
adjustment mode. (The currently
selected filter blinks.)
20
. Press and hold one of (F3) to (F6)
it is possible to check the stereo/
monaural setting of the sub-woofer
(Pe 13),
Press the (F3) of buttons [9] while
"LOW" is selected. "STEREO" or
"MONO" will be displayed for about 3
seconds.
buttons [9] for more than 2 seconds to
a0 He tBO Me
mute other speaker units other than the
40 Hz —~ 160 Hz
speaker unit using the filter to be
adjusted.
2.5 kHz — 10 kHz
The muting can be canceled by holding
the button depressed again for more
than 2 seconds.
(The bar of the muted speaker unit
displayed in the Operation display [15]
goes down.)
Each speaker unit (=filter) can be muted
separately. When a speaker unit is
50 Hz — 200
Hz (*1)
muted, its sound is not output any
50 Hz — 200 Hz (*2)
more. Adjust the network by switching
the speaker units ON/OFF as required.
(*1: 1/3 octave/step)
{*2: 2/3 octave/step)
(1/3 octave/step)
Advertisement
Table of Contents
