Sony UVW-1800P Service Manual page 210

Removal
Remove the Reel Cover, (Refer to section 6-5-1.)
Remove the Ree] Table. (Refer to section 6-5.)
Remove the Reet Disk. (Refer to section 6-7.)
Remove the spring of the Brake Assembly from
the Motor Plate Assembly as shown.
5, Remove the Stop washer 2.3 fixing the Brake
PYeNr
Assembly. Remove the Brake Assembly. Lining Assembly coring Stop washer 2.3
6. Remove the spring of the Lining Assembly from ;
the Brake Assembly.
Installation
7. Install a new Brake Lining Assembly by reversing Brake Assembly
the steps 5 and 6.
Adjustment after replacement Cas 1
8. Perform the Ree] Brake Clearance Check.
(Refer to section 6-13-1,)
9. Perform the Ree] Brake Releasing Check.
(Refer to section 6-13-2.)
10. Perform the Reel Table Installation.
Refer to section 6-5.)
11. Perform the Reel Table Height Check
(Refer to section 6-5-2.)
Ne
ia)
Lining Assembly
6-35