Sony UVW-1800P Service Manual page 282

[MANUAL Adjustment]
1, Connect an oscilloscope.
CH-1 ; TP-103/VP-43P and VP-43AP board (L-1)
CH-2 : TP-102/VP-43P and VP-43AP board (P-1)
'TRIG: CH-2
2, Display "MAINTENANCE MENU" on the monitor.
(1) Press the menu key while holding down the left key of
the subcontrot panel to display MAINTENANCE
MENU. Then the modes are displayed on the monitor.
3. Press the up or down arrow key to select "SERVO
ADJUST".
4. Press the right arrow key to display screen @.
5. Press the up or down arrow key to select "RF SWITCHING
POSITION".
6. Press the right arrow key to display screen @.
7. Press the up or down key to select "MANUAL".
8. Press the right key to display screen @ "START OK?".
9, Press the YES key.
MAINTENANCE MENU
MENU DATA CONTROL
EDIT CHECt
iis]
ISERVO ADJUST
SERVICE SUPPORT
OTHERS
MAINTENANCE MENU
SERVO ADJUST
S/T-REEL & CAPSTAN
S-REEL ONLY
T-REEL ONLY
@ CAPSTAN ONLY
TENSION
MAINTENANCE MENU
SERVO ADJUST
RF SWITCHING POSITION
AUTO
MANUAL
®
SERVO ADJUST MODE
START OK ?
NO.KEY : RETURN.TO MENU
YES KEY : ADJUST START