Sony UVW-1800P Service Manual page 82
Videocassette recorder / player
Hide thumbs
Also See for UVW-1800P:
- Operating instructions manual (83 pages) ,
- Operating instructions manual (60 pages) ,
- Operating instructions manual (49 pages)
Advertisement
3-4,
ERROR
MESSAGE
3-4-1,
Alarm
This unit features an alarm display function.
'When a problem is detected, an alanm is displayed immediately in the time counter display on the control panel and an alarm and the message
are displayed on the video monitor.
To display alarm and the message on the video monitor, the monitor must be connected to the VIDEO 2 (SUPER) OUTPUT connector, and
the CHARACTER switch on the sub control panel must be set to ON.
This unit features two types of alarms. One is for operators, and the other is for service persons.
This manual shows alarms only for service persons,
As for operators, refer to operation manual or overview in this manual.
Activating alarm display may influence to the system. For example, when the reference video signal is not used.
'Therefore, you can select whether or not to display the alarm from the Setup menu.
However, alarms for service persons are displayed regardless of Setup menn selection.
1.
Alarms will be displayed as soon as power is turned on.
ALARM
Detection
: Checks the settings of switch $1 on the SS-53 board
and
the
contents
of
electrically
erasable/
programmable ROM (EEPROM).
Operation after detection
: None
Display
_: Displays until any button is pressed.
Advertisement
