Table of Contents
Advertisement
Setup Wizard (Initial install)
After turning on the recorder for the first time
or after resetting the recorder, the Setup Wizard
menu is displayed.
You can set the display language, region,
programme scan, time and network setup on the
[Setup Wizard] menu.
1
Use v/V to select a language for the on-screen
display, and press OK.
Use v/V to select a region, and press OK.
Use v/V to select the [OK], and press OK to begin
programme scanning. The recorder automatically
searches for and saves the programmes.
If you select [Cancel], the [Auto Programming] function
will be skipped.
4
Use v/V to select an option among [Cancel], [Manual]
or [Auto], and press OK.
Auto: Set the programme that boadcasts a clock
signal and the clock will be set automatically.
If the time that has automatically set is not correct
comparing your local time, you can set additional time
option. Select an option relative to GTM in the [Time
Zone].
Manual: If there is no channel that broadcasts a clock
signal in your area, you can set the time and date
manually. Use b/B to select each field, and input
correct time and date using v/V.
5
Press OK to complete the [Time] setting.
6
Refer to "Wired network connection" on page 15-16 to
complete the [Wired LAN Setup] option, and press OK.
Select [Cancel] and press OK to cancel.
l
7
Refer to "Wireless network connection" on page 17-19
to complete the [Wireless Setup] option, and press OK.
Select [Cancel] and press OK to cancel.
l
This recorder can apply only one network setup
l
between [Wired LAN setup] and [Wireless Setup]. If
you already set the [Wired LAN setup] at step 6, you
do not need to set [Wireless Setup] setting.
You can reset the Setup Wizard from the [Initialization]
l
in the setup menu. (see page 49).
The [Initialization] option is not available while recording
l
or [Lock System] in the [Setup] menu is set to [On].
1
Advertisement
Table of Contents
