Table of Contents
Advertisement
Audio settings
This option allows you to listen to a movie at a lower
volume without losing clarity of sound.
Set [DRC] to [On] for the Dolby Digital encoded files only
and [Comfort] for files with any encoding method.
Selects the type of digital audio signal when using
the HDMI OUT or DIGITAL AUDIO OUT (OPTICAL or
COAXIAL) jack.
[HDMI PCM]: Select if you connect this recorder's HDMI
OUT jack to a device with two-channel digital stereo
decoder.
[HDMI Bitstream]: Select if you connect this recorder's
HDMI OUT jack to a device with LPCM, Dolby Digital,
Dolby Digital Plus and DTS decoder.
[SPDIF PCM]: Select if you connect this recorder's
DIGITAL AUDIO OUT jack to a device with two-channel
digital stereo decoder.
[SPDIF Bitstream]: Select if you connect this recorder's
DIGITAL AUDIO OUT jack to a device with LPCM, Dolby
Digital and DTS decoder.
[48KHz]: Select this if your A/V Receiver or Amplifier is
NOT capable of handling 192 KHz and 96 KHz signal.
When this choice is made, this unit automatically
converts any 192 KHz and 96 KHz signals to 48 KHz so
your system can decode them.
[96KHz]: Select this if your A/V Receiver or Amplifier is
NOT capable of handling 192 KHz signals. When this
choice is made, this unit automatically converts any
192 KHz signals to 96 KHz so your system can decode
them.
[19KHz]: Select this if your A/V Receiver or Amplifier is
capable of handling 192 KHz signals.
If audio signal is outputted through HDMI OUT jack
l
and the resolution is set to lower than 720p, the
sampling frequency can be limited to 48 KHz.
Check the documentation for your A/V Receiver or
Amplifier to verify its capabilities.
Display settings
Selects the aspect ratio of the connected TV.
[4: Letter Box]: Select this when connecting to a
standard 4:3 screen TV and prefer the wide picture with
bands on the upper and lower portions of the screen.
[4: Pan Scan]: Select this when connecting to a
standard 4:3 screen TV and prefer the wide picture on
the entire screen and cuts off the portions that do not fit.
[16:9 Original]: Select when a 16:9 wide TV is
connected. The 4:3 picture is displayed with an original
4:3 aspect ratio, with black bars appearing at the left
and right sides.
[16:9 Wide]: Select when a 16:9 wide TV is connected.
The 4:3 picture is adjusted horizontally (in a linear
proportion) to fill the entire screen.
(Digital Noise Reduction)
Set this option to [Auto] to reduce the digital noise, which
may appear especially on fast-moving pictures, produced
in the MPEG compression process.
Sets the output resolution of the Component and HDMI
video signal. Refer to "Resolution Setting" for details about
the resolution.
[Auto] – If the HDMI OUT jack is connected for TVs
providing display information (EDID), automatically
selects the resolution best suited to the connected TV.
If the COMPONENT VIDEO OUT is only connected,
this changes the resolution to 1080i as default
resolution.
[1080p] – Outputs 1080 lines of progressive video.
[1080i] – Outputs 1080 lines of interlaced video.
[70p] – Outputs 720 lines of progressive video.
[576p] – Outputs 576 lines progressive video.
[576i] – Outputs 576 lines of interlaced video
When the resolution is set to 1080i or 1080p, change this
option to [On] for smooth presentation of film material
(24Hz) with a HDMI-equipped display compatible with
1080/24p input.
47
Advertisement
Table of Contents
