Table of Contents
Advertisement
• When you select [ON], you may experience some
picture disturbance when the video switches video and
film material.
• When the 1080p 24Hz video source is outputted via
HDMI connection, the COMPONENT VIDEO OUT may
not visible any video signal.
Select an option according to the TV connection type.
[YPbPr] – When your TV is connected to the
COMPONENT VIDEO OUT jacks on the recorder.
[RGB] – When your TV is connected to the SCART
jack on the unit.
Record settings
Set this option to [On] to use the Time Shift function
automatically without pressing TIMESHIFT button. The
timeshift will start after TV viewing is started. Refer to
page 25 for more information.
This option sets the storage where your TV recording will
be stored. Select an option between [HDD (SATA)] or
[USB], and press OK to set.
Refer to page 25 for more information.
When you select [USB], make sure that there is sufficient
space for the recording on the USB HDD device.
Network settings
If you have connected this recorder to a local area
network (LAN)using LAN cable, the recorder needs to be
set up for network communication. (See "Wired network
connection" on pages 15-16.)
If you have connected the Wireless LAN adapter on this
recorder, the recorder needs to be set up for wireless
network communication. (See "Wireless network
connection" on pages 17-20.)
Your recorder is able to keep the built-in digital tuner
up to date with the latest software. You can either
check for updates manually, or set the recorder to do it
automatically at regular interval.
While the recorder is updating, there may be a disruption
in reception for a few hours. The reception should return
to normal after the update is complete.
This recorder must be plugged into AC power to receive
updates.
Do not unplug your recorder while an update is in
progress.
The update is not available during recording, Timeshift,
viewing teletext or EPG menu.
Standby mode : Updates the software when this
recorder is turned off. The check mark appears when
this option is selected.
Operation Mode : Update the software when this
recorder is turned on. The check mark appears when
this option is selected.
Refer to page 50 for more information.
You can update the software by connecting the recorder
directly to the software update server via wired or wireless
network connection to the Internet.Refer to page 50 for
more information.
Shows system information. (MODEL, CHIP ID or MAIN
VER)
Press OK or B to view the notice of Network Service
Disclaimer on page 58.
48
Advertisement
Table of Contents
