Making Sound; Turn The Power On . H - Yamaha V50 Operating Manual

ç>
MAKING SOUND
OO U Uuuu]
Now that connections are complete, we will explain how to make some sounds.
Turn the power on Any sound?
Turn on each device in your setup in the following order.
a)
—
Q
Check the following four items.
(1) Are all power cables correctly inserted into an
AC outlet?
(2) Are all connections correct?
(3) Are the amplifiers set to minimum volume?
(4) Is the V50 volume slider set to MIN?
The round button on the right side of the rear panel
is the power switch. Press it in to turn the V50 power
on.
Off On
The display will light up, and show the following
message. (You can modify the message in the lower
line of the display as explained on page 22.)
eA Et
In a short time this will change to a display similar
to the following.
* This display will be whatever was displayed when the V50
was last turned off, so details may be slightly different.
Turn the amp (keyboard amp, etc.) power on. (The
amp power is turned on last to protect the speakers
from possible damage.)
Note:
When several MIDI devices are connected, turn
them on beginning with the transmitting device.
When turning the power off, reverse this order
~1.e, turn off the amp, and then turn off the V50.
Now we will produce some sound.
a)
2)
(3)
Raise the volume of the amp. (The manual for your
amp will give details.)
Gradually raise the volume slider to increase the
V50 volume.
Press a key.
Is the V50 sounding? If not, check the following.
(1) Is the power of the V50 and the amp turned
on?
(2) Are the V50 and the amp correctly connected?
(3) Are the volumes of V50 and amp raised?
Hf after checking these three items you still hear no
sound, try the steps given on the following page. If
you still hear no sound, see page 122.
Now let's try out the various sounds of the V50.
Introducing the V50 11